back to top
Community

DIY Hover Plant Using An Old Steel Beer Can And A Cigar Box

Materials: cigar box, old steel beer can, and levitation device

Posted on
Cut the top off of an old steel beer can using a kitchen can opener

Cut the top off of an old steel beer can using a kitchen can opener

By using a steel can, there is no need for glue since the magnet will hold tight, however if you choose to use an aluminum can (or any other material for the planter) glue will be required

By using a steel can, there is no need for glue since the magnet will hold tight, however if you choose to use an aluminum can (or any other material for the planter) glue will be required

Air plants are highly recommended for this project

Air plants are highly recommended for this project

Drill a half inch hole in the back of a cigar box for the magnet power cord to feed through

Drill a half inch hole in the back of a cigar box for the magnet power cord to feed through

View this video on YouTube

youtube.com

The planter will gently spin for hours allowing your plant to receive 360 degrees of sunlight

This post was created by a member of BuzzFeed Community, where anyone can post awesome lists and creations. Learn more or post your buzz!
The best things at three price points