Skip To Content

    How To DIY A Cozy Headboard That Only Looks Expensive

    You will have a harder time building your Lack side table.

    by , ,
    Emily Shwake / BuzzFeed / Nifty

    Supplies:

    * Peg board (dimensions vary depending on bed and desired size)

    * 2-inch foam (same dimensions as peg board)

    * Foam batting (same dimensions as peg board PLUS about 8 inches allowance)

    * Fabric of choice (same dimensions as foam batting)

    * Extra strong upholstery thread

    * Fabric-covered buttons

    * Standard four-hole buttons

    * 6 inch upholstery needle

    * Staple gun

    * 2 picture frame hangers/fasteners

    * 2 1-inch screws

    * 2 2-inch nails

    1. Measure out a peg board to fit the width of your bed.

    BuzzFeed / Nifty

    King beds are usually 76 inches wide, queen beds are 60 inches, and full beds are 54 inches.

    2. Mark the center hole.

    BuzzFeed / Nifty

    3. Mark the fourth hole from the center hole on each side. From there, mark every eighth hole.

    BuzzFeed / Nifty

    These holes are for the buttons, so feel free to vary the frequency. if you want fewer buttons, count further out. Just keep your count consistent.

    4. Draw diagonal lines between the marked holes.

    BuzzFeed / Nifty

    5. Place the peg board on top of the foam. Poke an exacto knife through the hole into the foam.

    BuzzFeed / Nifty

    The holes should be about the size of a pencil.

    6. Attach the foam to the peg board with spray adhesive. Make sure the holes line up by gently poking your exacto knife through. If it hits foam, reposition the board.

    BuzzFeed / Nifty

    The adhesive dries pretty quickly so just give the board a nudge if you aren't sure.

    7. Lay the board across two elevated surfaces (a pair of chairs will do if you don't have anything higher). Attach the batting to the foam with your spray adhesive.

    BuzzFeed / Nifty

    Spread the foam batting evenly across the foam. Then, spray the adhesive in sections in between the two.

    8. Lay the fabric evenly across the foam batting. Then, poke a needle through a marked hole, and pull it through the front of the board. Thread the needle through your fabric button.

    BuzzFeed / Nifty

    9. Pull the needle through the same hole back to the peg board side. Pull the thread tight so that the button tufts or cinches the fabric.

    BuzzFeed / Nifty

    10. Cut off the needle and thread the two strings through the holes of a button and tie tightly.

    BuzzFeed / Nifty

    11. Pull the foam batting taut around the board and staple in place. Do the same to the fabric.

    BuzzFeed / Nifty

    12. Drill two holes in the corners of the top of your headboard. Use these holes to screw in hooks.

    BuzzFeed / Nifty

    13. Measure the distance between the hooks and hammer nails into the wall at a corresponding distance. Hang the bed.

    BuzzFeed / Nifty

    Watch the video here to see it in action.

    Follow BuzzFeed's Nifty for more neat home decor projects.

    Want awesome DIY tips in your inbox three times a week? Sign up for the BuzzFeed DIY newsletter!

    Newsletter signup form