How To Install A Whole House Water Filter System
If you are here right now, it’s obvious that you are thinking about buying a whole house water filter system or you just bought one, and now you want to know how to install it. Well, whatever the case is, if today you are here to learn how to install a water filter system, then you are at the right place because that’s exactly what we are going to talk about.

For starters, it’s a great step that you are about to take because a lot of people out there don’t know how important it is to use a water filter system. There are so many contaminants inside the water we use and drink, and the worst part is that the naked human eye cannot see these contaminants. This is why using a water filter system is the best thing to do if you really want to ensure that the water you are using isn’t damaging your health.
A whole house water filtration system can really make a big difference, and the best part is that you’ll be able to keep yourself protected from all the water-borne diseases. In a nutshell, it’s good that you are investing in such a product, and now let’s talk about the installation.
Guide To Install A Water Filter System
These are the steps you need to follow in order to DIY install a filter system in your house;
1- Shutting Off The Water Supply
The very first thing you need to do is to shut off your main water supply. This is a must before you start the process, and other than shutting it all off, you need to make sure that you are draining all the water that’s left in the pipes and faucets, etc. For this, you just have to open up all the fixtures and faucets until no more water is left in them.
2- Cut The Main Line
The next step is to cut into the mainline and make sure that you are cutting a big enough chunk that easily leaves you some space to put the water filter inside. In order to prevent spilling, just keep a bucket ready with you. Once done, you then have to sand down both the ends of the cut pipe.
3- Installing The Valves
Now is the time to install one valve on either side of the filter system because this way, you can easily manage the maintenance. Also, make sure to add a bypass valve so that you can get water inside your house even if the system is under service.
4- Dry Fitting
In this step, you need to do all the installation, and it requires a lot of dry fitting, so be prepared for that before time. The In and Out ports should be pointing in the correct direction. Use Teflon tape on all of the threaded ends to ensure that there are no leaks and tighten the plastic fittings carefully; otherwise, they’ll break. You’ll always get a manual with all the instructions regarding the installation of the whole house water filter system. So this is where you read the manual and follow what’s written.
Conclusion
Once you are done with the above-mentioned steps, you then have to turn back on the water supply. Open all the valves for the bypass and then let the water flow. Here it is! Your guide to installing a water filter system in your house without worrying about any complexity and complication. We hope you’ve now understood the process, so now, without waiting any further, follow the instructions and install the system right away.