Make Your Own In-N-Out Wallet
With a few simple tools and a spare few minutes, you could be the proud new owner of a In-N-Out Burger wallet. Get DIY, y'all.
-
1. Get a paper hat from In-N-Out
Just ask nicely when you order, and I'm sure they'll give you one. You'll also need tape and something to cut with.
-
2. Disassemble the hat
On the inside flap, it instructs you to PULL OUT to Your Head Size. Do this, but go even further.
-
-
3. Tear away the tissue paper.
Do it carefully; it should come right off.
-
-
4. Cut off the section for your wallet
The segment with In-N-Out on one side and the PULL OUT instructions on the other is just the right size. Cut at the fold. Careful with that knife!
-
5. Fold in half
-
6. Fold in the outer edges
Fold a small section, 1/3 to 1/4 of an inch.
-
7. Fit the edges
Now fold the wallet in thirds again, with the outer edge of the lower section coming over that of the upper section.
-
-
8. Tape the ends
-
-
9. Make a small slit in the top
You'll notice there's no place yet to stick yer cash. Make this small cut in the middle of the still folded over top...
-
10. ...then use your knife like a letter opener in both directions
-
11. Make a slit down the middle of the lower section, then fold the corners
-
-
-
12. Cut the tape right to the edge
This is to give your cards enough space to hang out.
-
13. Fill it with yer cash and junk!
You've got a wallet, friend!
-
Photos by Dobbins.